signal conditioning modules texxxxan series 201 4 .09.02-a/0 page 1 of 3 mornsun guangzhou science & technology co., ltd. reserves the copyright and right of final interpretation signal conditioning modules features z two-terminal isolation (signal input and output are mutually isolated) z high precision grade (0.1% f.s.) z high linearity (0.1% f.s.) z isolation voltage (2kvac/60s) z extremely low t emperature drift (50ppm/ ) z industrial grade (range of operating temperature: -40 to +85 ) z high reliability (mtbf >500,000 hours) z low ripple & noise: 30mvp-p(20mhz) z esd protection (iec/en61000-4-2 contact 4 kv perf. criteria b) z small footprint dip package(26*9.5*12.5mm) z signal load capacity: 2 k (@max. signal output @10v) texxxxan series is analog signal isolation modules with front-end positive/negative signal input and rear-end positive signal output. they are equipped with built-in efficient micro-power source can supply other power to the internal circuit of input signal. the product adopts the electromagnetic isolating technology as a substitute for the tradition al linear opto-isolator. in contrast, this type of product has a better performance in temperature drift, linearity, low power consumption and low ripple. they are two -terminal isolation (input of power supply , signal output and signal output are mutually isolated) selection guide part no. power supply input (vdc) input signal output signal isolation power output (vdc) TE5530AN 24 -10v~10v 0~10v nc te5650an 12 -10v~10v 0~5v nc te6630an 24 -5v~5v 0~5v nc input specifications item operating conditions value input power supply input voltage input nominal 5% input power signal full load 1w power protection anti-reverse connection protection input input signal see selection guide input impedance in case of max. input of voltage signal 10m over-load max. over-load voltage 30vdc out p ut s p ecifications item operating conditions value output output signal see selection guide load capacity voltage output 2k load regulation power voltage nominal, full load 2k , full scale output 0.05% power regulation power voltage nominal 5%, full load output 0.05% ripple & noise bandwidth 20mhz 35mvpp t ransmission specifications item operating conditions value zero offset 0.1%f.s. precision 0.1%f.s. temperatu re dri f t operating temperature range of -40 to +85 50ppm/ bandwidth 2khz response time 1ms
signal conditioning modules texxxxan series 201 4 .09.02-a/0 page 2 of 3 mornsun guangzhou science & technology co., ltd. reserves the copyright and right of final interpretation general specifications item operating conditions value electric isolation power input and the signal output are on the common ground. isolated between signal input terminal and signal output terminal. degree of isolation testing for 1 minute, leakage current <1ma, humidity <70% 2kvac isolation resistance 100m ? , 500vdc (signal input terminal and signal output terminal) operating temperature -40 ~+85 transportation and storage temperatu re -50 ~+105 max. operating temperature for casing ta=25 55 application environment the presence of dust, fierce vibration, impulsion and corrosive gas may cause damage to the product physical specifications casing material wh8100-f [1] package dip18 weight 8g(typ.) cooling method natural cooling emc specifications ems electrostatic discharge iec/en61000-4-2 contact 4kv perf. criteria b eft iec/en61000-4-4 signal input port 1kv(see fig. 2 for recommended circuit) perf. criteria b surge immunity iec/en61000-4-5 signal input port 1kv (line-to-ground)(see fig. 2 for recommended circuit) perf. criteria b application precautions 1. please read the instructions carefully before use; contact our technical support if you have any problem. 2. do not use the product in hazardous areas. 3. use dc power supply for the product and 220vac power supply is prohibited. 4. do not dismount and assemble the product without permission to avoid failure or malfunction of equipment. after-sales service 1. ex-factory inspection and quality control have been strictly conducted for the product; if there occurs abnormal operation or possibility of failure of internal module, please contact the local representative or our technical support. 2. the warranty period for the product is 3 years as calculated from the date of delivery. if any quality problem occurs under normal use within the warranty period, the product can be repaired or changed for free. applied circuit see application notes for isolated transmitter for details. design reference 1. wiring diagram for product application sout- sout+ sin- sin+ pin+ - + - + + gnd 18 16 11 10 2 1 8 9 nc 17 power supply input signal output signal input nc nc fig. 1 note 16,17,18 pin is the internal test pin, can not have any electrical connection to an external circuit.
signal conditioning modules texxxxan series 201 4 .09.02-a/0 page 3 of 3 mornsun guangzhou science & technology co., ltd. reserves the copyright and right of final interpretation 2. recommended emc circuit si n+ si n- TE5530AN tvs1 r1 si n+ si n- fig. 2 components recommended parameters r1 12 /2w tvs1 smbj15ca 3. for more information please find the application notes on www.mornsun-power.com dimensions and recommended layout notes: 1. packing information please refer to 'product packing information'. packing bag number: 58240002; 2. unless otherwise specified, data in this datas heet should be tested under the conditions of ta=25 , humidity<75% when inputting nominal voltage and outputting rated load; 3. all index testing methods in this datasheet are based on our company?s corporate standards; 4. the performance indexes of the product models listed in this datasheet are as above, but some indexes of non-standard model products will exceed the above-mentioned requirements, and plea se directly contact our technician for specific information; 5. we can provide product customization service; 6. specifications of this product are subject to changes without prior notice. mornsun guangzhou science & technology co., ltd. address: no. 5, kehui st. 1, kehui development center, science ave., guangzhou science city, luogang district, guangzhou, p. r. china tel: 86-20-38601850-8801 fax: 86-20-38601272 e-mail: info@mornsun.cn
|
